Instructions - 10 Litre Pail

Note: gordys flytrap fitting recommends this trap for high rainfall areas. Raise one side of the trap about 10 degrees to assist with water run-off.

Requirements

10 Litre Pail,
Marker Pen,
Tin Snips (or similar cutting device),
Gordys Flytrap Fitting.

Using the Marker Pen - mark out an area of approximately 60% of the lid, ensuring you leave a 25mm boarder from lip of the lid.
Using the Tin Snips, cut out the marked area.
Place Gordys Flytrap Fitting into cutting in the lid to ensure fit.

Your container is now ready to use. For information on baiting and setting the trap, please read our instructions page.